Nemtek electric fence energisers fitted and upgraded across Johannesburg and Gauteng

The energiser is the box that powers your electric fence and raises the alarm when the fence is cut, shorted or earthed. We fit Nemtek energisers sized for your fence, split the fence into zones, and link it to your alarm and your phone.

Our own jobs run on Nemtek energisers, from a home in Brackenhurst to ten Druid 28 LCDs on a 3 km industrial wall.

Solar-powered electric fence energiser inside its own fenced cage with warning signs, rural site, Gauteng

Signs the energiser is the weak part of your fence

  • The alarm goes off, and nobody can tell you which side of the fence it was.
  • The reading at the far end of the fence is far lower than at the energiser.
  • The fence goes dead partway through a long power cut.
  • Fence alarms never reach your phone or your armed response company.

An electric fence energiser does two jobs: it pulses the fence and it watches it

An energiser sends a short, high-voltage pulse along the live wires, over and over. Touch a wire and you get a sharp shock. The pulse runs out along the fence and back through the earth spikes, which is why a weak earth weakens the whole fence.

It also keeps watch. Nemtek’s Druid energisers, for example, monitor the live wires and the earth wires, and when a wire is cut, shorted or earthed, the energiser sounds the siren and can signal your alarm panel and armed response company.

A security energiser must carry a SANS 60335-2-76 test certificate, and a farm energiser built for livestock is the wrong box for a security fence. Nemtek spells it “energizer”; it’s the same thing.

We size the energiser for your fence, with power to spare

Energisers are rated in joules. Every metre of wire, every extra strand and every plant brushing the fence draws on that output, so a small energiser on a long fence leaves the far end weak.

We size it by the length of the fence, the number of strands and zones, and what grows along it, and leave headroom so the far end stays strong in wet weather and as the fence ages.

Past a certain length, one energiser isn’t enough. At a distribution centre in Centurion, 3.2 km of wall runs off 14 energisers in seven field stations.

Electric fence brackets and strands running the length of a tall precast concrete wall beside a road in Centurion

Our job: a 3.2 km wall-top fence split into 28 zones, Centurion.

Zones and monitored energisers show you where the fence was touched

A zoned energiser splits the fence into sections and watches each one on its own. When a zone alarms, the screen shows which one, so you and your armed response know which wall to check.

Nemtek’s Druid 28 LCD runs two independently monitored zones, and its screen changes colour with the state of the fence.

On long boundaries we go further. At an industrial site in Maputo, ten Druid 28 LCD energisers run 20 zones and report over a wireless network to one monitoring PC, so the whole wall is watched from one screen.

Your energiser can report to your alarm, your armed response and your phone

  • Nemtek’s Druid energisers can trigger a separate alarm panel, and connect to an armed response radio or GSM unit.
  • With a Nemtek Connect gateway, fence alarms and faults come through to the Nemtek Connect app on your phone.
  • On a Meyerton property we fitted an Olarm module, so the owner gets fence alarms on the phone and arms and disarms from it.
  • If you have an Ajax alarm, a transmitter on the energiser puts fence alarms in the Ajax app with everything else.
  • Pick 4G or Wi-Fi for any gateway. South Africa is switching 2G and 3G off, with the end of 2027 as the target.

A backup battery keeps the fence live through power cuts

Mains-powered energisers such as Nemtek’s Druid range carry a backup battery that the mains keeps charged, so the fence stays live and armed when the power goes off.

How long the battery lasts depends on the energiser, the battery and how much fence it drives, and on some fences it isn’t long. So we don’t promise a number of hours: we size the battery for your fence and test it on every service.

Frequent power cuts wear batteries out faster. Where there’s no mains at all, a solar panel and a deep-cycle battery can run the energiser, as on the Meyerton fence.

Lightning protection stops a storm from killing the energiser

Summer storms are a common way to lose an energiser. A strike near a long fence can send a surge down the wires and into the box.

  • A lightning diverter sits between the live wires and its own earth spike, before the energiser, and gives the surge a short way to the ground.
  • Surge protection goes on the mains supply, and on the cables that link the energiser to an alarm panel or gate motor.
  • A good earth helps carry a surge away, as well as making the fence work.

At the Centurion distribution centre, each field station has four surge arresters, and the fence has 28 lightning diverters. More in our guide to lightning and your electric fence.

A fence tester reads the voltage, and a fault finder points to the leak

A fence tester is held against a live wire and reads the voltage of the pulse at that spot. Read it near the energiser and again at the far end. A big drop along the way means the pulse is leaking somewhere.

A fault finder goes further. Nemtek’s fence meter shows the voltage, the current and the direction of a fault, so you can follow it along the fence to the branch, the cracked insulator or the wire touching a bracket.

The energiser’s own screen tells you a lot too: many show the fence voltage and name the fault, and a zoned one tells you which section to walk. Never test a fence by touching it. We test every zone when we hand a fence over, and on every maintenance visit.

Projects

Fences and energisers we’ve fitted lately

See more of our work

Send us a photo of your energiser and its screen, and the rough length of the fence.

When to replace an old energiser instead of nursing it along

  • It can’t tell you which part of the fence has the fault.
  • It has no test certificate, or nobody knows the make.
  • It has been hit by lightning, or keeps dying after storms.
  • It can’t drive the fence you have now, after strands or a section were added.
  • Its alerts still go out over 2G or 3G.

Replacing the energiser counts as an alteration, so the fence needs a new electric fence certificate afterwards. We’re registered installers, so we fit the energiser, test the fence and issue the certificate in the same job. See electric fence COC inspections.

A new energiser in four steps

  1. You WhatsApp us a photo of the fence and the old energiser, if there is one, with the rough length.
  2. We work out the size, the zones and how it should report, and send a written quote listing the energiser, battery, lightning protection and any gateway.
  3. We fit the energiser in a weatherproof box, earth it, fit the lightning diverter, and connect the zones, the siren and your alarm.
  4. We test every zone, set up the app if you have one, issue the electric fence certificate and show you how to read the screen.

What moves the price of an energiser upgrade

The size of the energiser and its number of zones, the battery, the lightning protection, any gateway for app alerts, and whether the earthing and zones need work to match. You get the quote in writing, and we don’t go over it without your OK.

Putting up a whole new fence? Our electric fence price guide explains what drives the cost.

Get an energiser quote on WhatsApp

Send a photo of the fence and its rough length. We’ll tell you which energiser it needs, and why.

Questions

Questions people ask us

What does an electric fence energiser do?

It sends a short, high-voltage pulse along the live wires and watches the fence. When a wire is cut, shorted or earthed, it sounds the siren and can signal your alarm panel, your armed response company and your phone.

Which Nemtek energiser do I need?

One sized for your fence’s length, strands and zones, with power to spare. A short home wall may be one zone; long boundaries need more zones, and sometimes more than one energiser. Send us the rough length and a photo, and we’ll tell you which model and why.

How long does an electric fence battery last in a power cut?

It depends on the energiser, the battery and how much fence it drives, so we don’t promise a number of hours. We size the battery for your fence. Frequent power cuts wear batteries out, so have yours tested on a service.

How long do electric fence energisers last?

There’s no fixed lifespan. Lightning, water getting into the box and a fence too big for the energiser all shorten it, which is why lightning protection and a good earth go in with every energiser we fit.

Does a new energiser need a new fence certificate?

Yes. Replacing the energiser counts as an alteration, so the fence has to be inspected and certified again. We fit the energiser and issue the certificate in the same job.

What does an electric fence tester show?

The voltage on the wire where you hold it. A fault finder, like Nemtek’s fence meter, also shows the current and which direction the fault is in, so you can walk to it instead of checking the whole fence.

Can my electric fence send alerts to my phone?

Yes. A Nemtek Connect gateway sends fence alarms to the Nemtek Connect app, or an Olarm module or an Ajax transmitter on the energiser puts them in the app you already use. Choose a 4G or Wi-Fi gateway, not 2G.

Get in touch

Send us a photo of the fence, and of the energiser if there is one

WhatsApp a photo and the rough length, or call us, Monday to Friday, 08:00 to 17:00. We fit energisers from Walkerville across Johannesburg, Pretoria and Centurion, the East Rand and the Midvaal.

Or leave your details

We use your details only to reply to you about this request. See our privacy notice.